Home Profile Products Enquiry contact us

    

ZINC WIRE MIG WIRE SAW WIRE

 
   
 

ZINC WIRE

Zinc wire is primarily used for metal spraying on iron and steel parts for protection against atmospheric and galvanic corrosion. Metal spraying is also employed for building-up worn metal surface and recommended where hot dip galvanising is not physically and economically feasible. 
We are pleased to offer you with the following advantages:
ZINC WIRE
:- High quality material: all out products are produced in a strictly process under ISO 9001 quality control management.
:- Purity is more than 99.995% with low percentage of impurity.
:- Remarkable adhesiveness.
:- The surface of wire should be clean, smooth, and free from blister & roughness.
   
Mechanical properties:
Elongation  (%) 40-42%
Density  (g/cm3) 7.14g/cm3
Melting point  (C) 419ºC
Boiling point (ºC) 907ºC
Tensile strength (N/mm2) 11.2 N/mm2
Diameters and Tolerance: 
Wire is available in the following diameter: 2.00, 2.50, 3.15, 4.00 (mm)
The tolerance on diameter of the wire shall be: +0, -0.05(mm) 
Packing:
Zinc wire shall be supplied in coils of continuous lengths, closely coiled without any loose turns. The inner diameter of the coil shall be 300-600 mm. The coils shall be bound and fastened compactly at two places on the opposite ends of a diagonal of the coil using binding wires. Inside, the coil is packed by polythene and outside, by Hessian cloth.
 
 
 
 
 
Copyright 2007-2008 Super Wire Industries All Rights Reserved.
Powered by: